Diamondback 860Er Bedienungshandbuch PDF herunterladen (Seite 12)

860 Er Owner’s Manual

Heart Rate Monitoring Devices

Pulse Hand Grips (Standard)

The 860Er unit is heart rate controlled and comes standard with stainless steel pulse hand-

grips. To activate, gently grasp both handgrips to obtain a heart rate reading.

(Note: It is recommended to wear a chest strap for Heart Rate control program, as it is more

accurate. If you wear a chest strap and use hand grips at the same time for heart rate mon-

itoring purpose, please note the console will take the measurement of the chest strap.)

Operating Tips:

If you are not getting a consistent reading while using the hand pulse option, we rec-

ommend the following suggestions:

• Make sure that the palms of the hands are touching the contact area of each

hand pulse grip.

• Maintain an even pressure on the grips.

• Do not hold the hand pulse grips too tightly.

Chest Strap (Standard)

The 860Er is equipped a built-in receiver and a chest strap for your heart rate monitor-

ing. To get an accurate reading using these devices, you will need to be within three

feet of the console, and a minimum of four feet from others using a heart rate monitor-

ing device.

(Note: The transmitter may fluctuate erratically if you are too close to other heart rate

monitoring equipment or there is other electronics near by, such as TV, Radio...)

The receiver of the wireless ECG system is built into the console unit of the Diamondback

860Er equipment. While using heart rate control modes, the computer monitors the

exact measurement of and control over the activity if the heart. Heart rate frequency is

displayed while the computer continually compares heart rate to the preprogrammed

personal data. The computer adjusts the wattage to maintain heart rate at the prepro-

grammed level.

How to Wear Your Sensor/ Transmitter

1. Buckle one end of the chest strap onto the transmitter.

2. Adjust the band length so that the fit is snug, but not too tight.

3. Buckle the other end of the chest strap onto the transmitter.

4. Center the transmitter on your chest below the pectoral muscle (breasts).

5. Stretch the transmitter away from your chest and moisten the conductive electrode

strips located next to the buckles with water.

(Note:

The transmitter is on automatically when being worn. It is off when it is not con-

nected to your body. However, as moisture may activate the transmitter, thoroughly dry

the transmitter to prolong battery life.)

Erratic Heart Rate Readings:

Erratic readings on the receiver can be caused by electromagnetic disturbances. If the heart

rate readings appear to be abnormal, check that your 860Er product is not within range

of other strong electromagnetic signals. Common sources are televisions, computers, cars,

cell phones, TV antennas and high voltage power lines (both above and below ground).

Please note: Static electricity in clothing or a flapping shir

t can cause electrical interference,

so some items of clothing, i.e. man-made fibers, can also be the cause. Please try wetting

the t-shirt in the area where the transmitter is.

If the battery of the transmitter is running low, the transmission range decreases and may

cause errors similar to the ones listed above in this document

Battery Replacement:

To replace the transmitter battery, remove the four small screws securing the cover plate in

the back of the transmitter. Remove the cover plate, and the thin plastic shield covering the

battery, Remove the battery and replace with a new CR 2032 battery (available at photo

or watch departments). Make sure the battery snaps into place and the numbers are fac-

ing up. Replace the plastic shield and cover plate with four screws.

860erOM 6/20/06 8:42 PM Page 14

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Kommentare zu diesen Handbüchern

Keine Kommentare

Diamondback 860Er Bedienungshandbuch Seite 12

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Fitness, Gymnastik & Krafttraining Diamondback 860Er